====== Base SSG configuration for INLINE scheme ======
{{indexmenu_n>3}}

  - Prepare the server according to the [[dpi:dpi_brief:dpi_requirements|installation requirements]].
  - Install and configure the [[veos:first_install:ipsetincenos|VEOS OS]]
  - Set an [[veos:first_install:ipsetincenos|IP address]].
  - Apply for license installation and fastDPI to [[dpi:techsupport_info|Service Desk]].
  - After installing them, the following settings must be made in **''etc/dpi/fastdpi.conf''**:  
    * Set up transit: <code bash>
in_dev=01:00.0
out_dev=01:00.1
#Scale factor is about 1 for every 1 Gigabit of bandwidth
scale_factor=10
timeout_check_dev=0

#FastDPI Control
ctrl_port=29000
ctrl_dev=lo

#Turn on UDR
udr=1
</code>
    * Statistics gathering: <code bash>
#FullNetflow/IPFIX
netflow=8
netflow_full_collector_type=2
netflow_dev=eth3
netflow_timeout=20
netflow_full_collector=172.18.254.124:1500
netflow_rate_limit=30
netflow_passive_timeout=40
netflow_active_timeout=120

#ClickStream/IPFIX
ipfix_dev=eth3
ipfix_tcp_collectors=172.18.254.124:1501

#SIP
ipfix_meta_tcp_collectors=172.18.254.124:1511
rlimit_fsize=32000000000</code>
  - Further settings are made depending on which components are to be used. The settings are described in the [[dpi:dpi_components|]] section.