Base SSG configuration for INLINE scheme

  1. Prepare the server according to the installation requirements.
  2. Install and configure the VEOS OS
  3. Set an IP address.
  4. Apply for license installation and fastDPI to Service Desk.
  5. After installing them, the following settings must be made in etc/dpi/fastdpi.conf:
    • Set up transit: 
      in_dev=01:00.0
out_dev=01:00.1
#Scale factor is about 1 for every 1 Gigabit of bandwidth
scale_factor=10
timeout_check_dev=0
 
#FastDPI Control
ctrl_port=29000
ctrl_dev=lo
 
#Turn on UDR
udr=1
    • Statistics gathering: 
      #FullNetflow/IPFIX
netflow=8
netflow_full_collector_type=2
netflow_dev=eth3
netflow_timeout=20
netflow_full_collector=172.18.254.124:1500
netflow_rate_limit=30
netflow_passive_timeout=40
netflow_active_timeout=120
 
#ClickStream/IPFIX
ipfix_dev=eth3
ipfix_tcp_collectors=172.18.254.124:1501
 
#SIP
ipfix_meta_tcp_collectors=172.18.254.124:1511
rlimit_fsize=32000000000
  6. Further settings are made depending on which components are to be used. The settings are described in the SSG components section.