The SSG installation manual using INLINE installation scheme
- Prepare the server according to the installation requirements.
- Install and configure the VEOS OS
- Set an IP address.
- Apply for license installation and fastDPI to Service Desk.
- After installing them, the following settings must be made in
etc/dpi/fastdpi.conf:- Set up transit:
in_dev=01:00.0 out_dev=01:00.1 #Scale factor is about 1 for every 1 Gigabit of bandwidth scale_factor=10 timeout_check_dev=0 #FastDPI Control ctrl_port=29000 ctrl_dev=lo #Turn on UDR udr=1
- Statistics gathering:
#FullNetflow/IPFIX netflow=8 netflow_full_collector_type=2 netflow_dev=eth3 netflow_timeout=20 netflow_full_collector=172.18.254.124:1500 netflow_rate_limit=30 netflow_passive_timeout=40 netflow_active_timeout=120 #ClickStream/IPFIX ipfix_dev=eth3 ipfix_tcp_collectors=172.18.254.124:1501 #SIP ipfix_meta_tcp_collectors=172.18.254.124:1511 rlimit_fsize=32000000000
- Further settings are made depending on which components are to be used. The settings are described in the SSG components section.